- name :
- email :

Vote the best picture .

designed by @.t.n.s

All you need is a philips type screwdriver,
for the installation of Lusifer mod!

The installation of Lusifer mod is so easy,
that only 10 minutes needed to fit it in your console!
It is strongly recomended to be done by experienced technics, as it requires to open your console and break the quarrantee shield!

step#1
Unscrew 6 black screws.

step#2
Lift the upper cap of PS2.

step#3
Take care of the ribbon cable that connect the upper cap with PS2.

step#4
Disconnect the eject-reset button,
with the elp of a screwdriver.

step#5
Disconnect the ribbon cable from the eject-reset button.

step#6
Connect the ribbon cable in Lusifer mod.
1. Always in the connector that you see in the photo!
2. Always keep ribbon contacts like the photo!

step#7
Connect the extra ribbon cable to Lusifer mod,
1. Always in the connector that you see in the photo!
2. Always keep ribbon contacts like the photo!

step#8
Connect the other side of the extra ribbon cable, to the eject-reset button.
1. Always keep ribbon contacts like the photo!

step#9
Place eject-reset button back in his place.

step#10
Unscrew this 2 screws that connect cd-rom with PS2 case.

step#11
Lift the cd-rom.
1. Watch out for the ribbon cable that connect cd-rom controler with the mainboard.

step#12
Find and disconect a red-black cable.
Always use G1-Plug In for scph-3xxxx models!

step#13
Place Lusifer mod, in the upper cap of PS2,
and connect the other side of G1-Plug In to Lusifer mod,
and ENJOY YOUR GAME!