/ home / Installation help / SCPH-3xxxx / V1-V2 consoles

These versions can be found only in NTSC systems:
- model number: SCPH-3xxx1
- serial number: u1xxxxx/u0xxxxx
---------------------------------------------------------------------
GRmods is based in Europe (PAL consoles),
so no proper Plug In has been manifactured yet for these versions.
---------------------------------------------------------------------

Lusifer mod: Installation Guide in V1/V2 consoles

click the image to enlarge

Thanks to one of Lusifer modchip beta testers in US systems, named AgentMZ, here is the exact points that you have to solder in Lusifer board.

Just cut the wire shown in the picture in 2 parts, and connect Lusifer modchip in the GRD.

Installation Help

Step#1
Cut the wire shown in the photo, in 2 parts, and connect:
- left edge to point 1
- right edge to point 2

Step#2
Connect with a wire the point GRD from the photo, to the ground of PS2.

Step#3
Use G1-Plug In to connect the CD-Rom to Lusifer mod.

Soon an extra G0-Plug In will be manifactured,
for the Plug&Play installation of these models!
Till then, you can easilly fit it, like shown in the photo!

Lusifer full: Diagrams for V1/V2 consoles - 3 points to solder !

Lusifer full requires 3 extra points to solder,
that can be found in the existing neo2.2 diagrams (pin2, pin4, pin7).
------------------
- Diagrams
------------------
Soldering in PS2 mainboard,
may cause a tune off to your Laser Adjustment.