/ home / Installation help / SCPH-5xxxx / V9-V10 consoles

Only 10 minutes, one Philips type screwdriver and a pair
of pincers required for the installation of Lusifer mod!
With simple Plug&Play actions (No-Sodlering),
you may now hack your brand new Play$tation2, allowing original imports and backups to be loaded
with Swap Magic Disks and 1 easy swap!

Are U gonna Risk it with Soldering?

The installation of Lusifer mod in V9/V10 consoles will be performed by a 15 years old girl, called L1:

"I managed to install L-mod V9 in less than 10 minutes
and I will show you how easy it is!
Meanwhile, for any damage you may cause in your PS2,
you are responsible about that, Don't blame me..."

Lusifer mod: Installation Guide in V9/V10 consoles - by L1 (15 years old)

Use the Philips type screwdriver to unscrew the 8 screws that are hiding under the 8 plastic pads,
from the bottom side of PS2 console.

Lift the Top cap of PS2.

Warning: By opening your PS2 console,
you are voiding the quarantee shield!

Unscrew 2 screws that are holding
Joystic/Memory socket.

Unscrew 2 screws that are holding
the Ventilator.

Warning: 1 screw is hiding, underneath Power Switch!

Put the Top cap back in its place
and remove the Bottom cap.

Now, Plug G3 Plug-In to Lusifer mod connectors.

- Remove the Ribbon Cable that is connecting Power/Eject Buttons with PS2 mainboard.

- Unplug the other Ribbon Cable that is connecting
DVD-Rom with the mainboard and Plug it
to G3 Plug-In connector.

Plug G3 Plug-In to PS2 mainboard
and check from the up side if it is properly connected.

Plug the other edge of G3 Plug-In to Power/Eject connector.

Simple place Lusifer mod as in the photo
and you have just Finished with the installation!

Put back all parts in their place,
and hold Eject Button continuously,
till the DVD-Rom tray opens.

Lusifer full: Diagrams for V9 consoles - 3 points to solder!